Living in a little bit of life, with a new home, the excitement and joy of the heart, when you face the renovation after the collection, you inevitably distressed to buy and install some hardware, some simple problems, we can Dealing with the tap, we often use it in our daily life, so how to install and clean the tap?
How to install a tap
What should you pay attention to when installing? Cold and hot water supply pipes must not be installed in reverse. Under normal circumstances, the face of the faucet is a hot water supply pipe on the left and the cold water supply pipe on the right. Except for special signs. After the installation is completed, remove the bubbler, shower, etc., and easily block the fittings so that the water flows out and the impurities are completely clear. The tools attached to the faucet should be retained for future maintenance. When disassembling the inlet hose, do not wrap the sealing tape. Do not use a wrench and tighten it by hand. Doing so can damage the hose. The wall-mounted faucet determines the length of the elbow as needed, or the elbow is exposed to the wall too much, affecting the appearance. Install faucets as far as possible before installing basins, bidets, sinks, and bathtubs.
For thermostatic faucets, the static pressure of hot and cold water supply is recommended to be 3bar (0.3MPa) and the minimum water supply pressure is 0.5bar (0.05MPa). The pressure difference between hot and cold water supply is not more than 2bar (0.2MPa). If the water supply pressure is greater than 5bar (0.5MPa), install a pressure reducing valve. For thermostatic faucets, the hot water supply temperature range is 50°C-80°C, and the recommended hot water supply temperature is 65°C. For in-wall taps, if necessary for heating and welding, be sure to remove plastics and rubber parts such as spools. Before entering the wall-mounted faucet, check whether there is any leakage in the test connection and repair as required. When pressure test is done, be sure to empty all air in the pipe and faucet.
Faucet cleaning
Clean the surface of the coating with neutral soapy water, then thoroughly wipe the entire surface with a clean, soft cloth. Many cleaning agents such as ammonia, detergent powder, and toilet gel can cause damage to the plated surface. Please do not use it and wear it. Sex cleaning utensils or detergents should not be used for Koehler brand faucets and accessories.
Hydropower installation hydro-reform faucets
Commercial Carpet,Weeding Carpet,Exhibition Carpet
Geomembrane,Shrink Film / Stretch Film Co., Ltd. , http://www.chgeomembrane.com