(1) Friction coefficient: where F is the force measured by the anti-slip test to cause the initial slip of the test piece, and nf is the number of friction faces, which is the sum of the measured values ​​of the high-strength bolt tightening pre-tension corresponding to F. (2) Torque factor: where d is the nominal diameter of the high-strength bolt (mm), M is the applied torque value (N.M), and P is the bolt pre-tightening force. The 10.9 high-strength large hex bolt connection must ensure that the average value of the torque coefficient K is 0.110~0.150. The standard deviation should be less than or equal to 0.010.
(3) Initial tightening torque: In order to reduce the influence of steel plate deformation during bolt tightening, secondary tightening can be used to reduce the mutual influence between successive tightening bolts. The high-strength bolt is first twisted for the first time, so that the axial force should reach 60%-80% of the standard axial force.
(4) Final tightening torque: The torque for the final tightening of the high-strength bolt is the final tightening torque. Considering the loss of various prestressing forces, the final tightening torque is generally 5% to 10% greater than the theoretically calculated torque value according to the design pretension.
Phosphated Black Hex Nut Setter
nut setter,hex nut setter,magnetic hex nut setter,Phosphated black Hex nut setter,nut setter factory
henan horn tools co.,ltd. , http://www.horntoolsltd.com